WEA 10 Water softening system incl. 1 salt pack 25 kg

Individual system for softening/partial
softening of cold drinking water.
Designed in accordance with DIN EN
14743 and DIN 19636-100. Quantity-
controlled regeneration with economy
salting. All inlet connections must be
protected by spring-loaded non-return
valves. This eliminates the need to
install a pipe or system separator.
Compact design with electronic control
unit, multi-port valve with water meter
and integrated blending valve. Anti-germ
device which disinfects the exchanger
resin during regeneration. Menu-guided
microprocessor control for different
operating modes with the following
functions and displays: Diagnostic mode,
fault detection with indication in the
display, residual capacity and flow rate
display, Pressurised tank with ion
exchanger Integrated salt storage
compartment with filling opening, safety
float valve/ safety overflow

Technical data:
Nominal capacity DIN EN 14743 (m³x°dH): 18
Nominal flow rate at < 0.5°dH (m³/h): 1.4
Max. flow rate (m³/h): 2.4
(with blending from 20°dH to 8.5°dH)
Pressure loss (bar): 0.31
Salt supply (kg): 50
Height (mm): 1140
Width (mm): 320
Depth (mm): 500
Connections: R 1”
Operating pressure min./max. (bar): 2,0 / 8,0
Ambient temperature min./max. (°C): 5/40
Water temperature min./max. (°C): 5 / 30
Electrical connection: 230 V / 50 Hz

Mounting block with blending and
backflow preventer DN 25, 1 ‘x1 “x1 1/4”
Armoured hose 2x1 ‘ÜM, DN 25, KTW
DVGW-tested, length 80 cm
Connections with flat sealed nipple
and connection nut on both sides 1’
Temperature range: +5 °C to +80 °C
Total hardness measuring set

incl. 1 bag of regeneration salt